章節 | 擬訂 | 備註 |
簡介 (introduction) | ||
1. 範圍 (scope) p. 5 | ||
2. 規範性參考文件 (normative reference) p. 5 | ||
3. 定義 (definitions) p. 6 | ||
4. 可恃性分析基本程序 (basic dependability analysis procedure) | 標題 | |
4.1 一般程序 (general procedure) p.7 - 8 | ||
4.2 可恃性分析方法 (dependability analysis methods) p. 8 - 10 | ||
4.3 可恃性配當 (dependability allocation) p. 10 - 11 | ||
4.4 可恃性分析 (dependability analysis) | 標題 | |
4.4.1 方法之分類 (categories of methods) p. 11 - 12 | ||
4.4.2 由下而上法 (bottom-up methods) p. 12 | ||
4.4.3 由上而下法 (top-down methods) p. 12 - 13 | ||
4.5 維護與修理分析及考量 (maintenance and repair analysis considerations p. 13 | ||
5. 選擇適切之分析技法 (selecting the appropriate analysis techniques) p. 13 - 14 | ||
附錄A:分析技法摘要說明 (brief description of analysis techniques) | 標題 | |
A.1 主要可恃性分析技法 (primary dependability anallysis techniques) | 標題 | |
A.1.1 失效率預估 (failure rate prediction) | ||
A.1.2 故障樹分析 (fault tree analysis) | ||
A.1.3 事件樹分析 (event tree analysis) | ||
A.1.4 可靠度方塊圖分析 (reliability block diagram analysis) | ||
A.1.5 馬可夫分析 (Markov analysis) | ||
A.1.6 派萃網分析 (Petri net analysis) | ||
A.1.7 失效模式與效應分析 (failure modes and effects analysis) | ||
A.1.8 危害與操作性研究 (hazard and operability study, HAZOP) | ||
A.1.9 人員可靠度分析 (human reliability analysis) | ||
A.1.10 應力強度分析 (stress - strength analysis) | ||
A.1.11 真值表 (true table) | ||
A.1.12 統計可靠度方法 (statistical reliability method) | ||
A.2 精選支援方法 (selected supporting methods) | 標題 | |
A.2.1 潛行線路分析 (sneak circuit analysis) | ||
A.2.2 最惡劣狀況分析 (worst case analysis, WCA) | ||
A.2.3 變異數模擬模型 (variation simulation model) | ||
A.2.4 軟體可靠度工程 (software reliability engineering, SRE) | ||
A.2.5 有限元素分析 (finite element analysis, FEA) | ||
A.2.6 零件減額定與選擇 (parts derating and selection) | ||
A.2.7 帕雷托分析 (Pareto analysis) | ||
A.2.8 原因與效應圖 (cause and effect diagram) | ||
A.2.9 失效通報分析與改正行動 (failure reporting analysis and corrective action, FRACAS) | ||
B.1 生命周期規劃 (life cycle planning) | ||
B.2 環境工程 (environmental engineering) | ||
歡迎光臨 睿地可靠度論壇(TW-REDI Forum) (http://m1.kdi.tw/) | Powered by Discuz! X2 |