睿地可靠度論壇（TW-REDI Forum）

標題: 2. 正式引用文件 [打印本頁]

作者: hlperng 時間: 2013-12-30 11:26:35 標題: 2. 正式引用文件

本帖最後由 hlperng 於 2013-12-30 11:30 編輯

2. Normative References
The following referenced documents are indispendable for the application of this document. For dated references, only the edition cited applies. For undated reference, the latest edition of the referenced document (including any amendaments) applies.

IEC 60050 (191):1990, International Electrotechnical Vocabulary (IEV) - Chapter 191: Dependability and quality of services

IEC 60300-3-2:1993, Dependability management - Part 3: Application guide - Section 2: Collection of dependability data from field

IEC 60300-3-4:1996, Dependability management - Part 3: Application guide - Section 4: Guide to the specification of dependability requirements

IEC 60300-3-5:2001, Dependability management - Part 3: Application guide - Section 5: Reliability test conditons and statistical test principles

IEC 60300-3-10:2001, Dependability management - Part 3-10: Application guide - Maintainability

IEC 60706-1:1982, Guide on maintainability of equipment - Part 1: Section one, two and three - Introduction, requirements and maintainability programme
IEC 60706-2:1990, Guide on maintainability of equipment - Part 2: Section five - Maintainability studies during the design phase

IEC 60812:1985, Analysis techniques for system reliability - Procedure for failure mode and effects analysis (FMEA)

IEC 61078:1991, Analysis techniques for dependability - Reliabilty block diagram method

IEC 61165:1995, Application of Markov techniques

IEC 61709:1996, Electronic components - Reliability - Reference conditions for failure rates and stress models for conversion

IEC 61882:2001, Hazard and operability studies (HAZOP studies) - Application guide

ISO 9000:2000, Quality management systems - Fundamentals and vacalbulary

- , Bludprints for Product Reliability, Reliabilitiy Analysis Center (RAC) 1996.

歡迎光臨睿地可靠度論壇（TW-REDI Forum） (http://m1.kdi.tw/)